Automated Logic LGC 기술 지침 - 페이지 2
{카테고리_이름} Automated Logic LGC에 대한 기술 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Automated Logic LGC 7 페이지.
페이지 인쇄Using the LGC
The LGC is part of the LANgate family and
provides communication between a
workstation and a control module network
(CMnet) consisting of fewer than 100
modules.
The LGC communicates with the CMnet using
an EIA-485 connection. The CMnet is a peer-
to-peer network that allows all control
modules to communicate with equal
authority using a token-passing protocol.
EIA-232
Console Port 1
EIA-232
Console Port 2
Auxiliary
Device Port
CMnet Baud
Rate Jumper
Access Port
LEDs
NOTE This equipment has been tested and
found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated
in a commercial environment. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
Revised 6/16/00 • LGC
A workstation can communicate with the LGC
directly or through a modem. The LGC
provides two EIA-232 Console Ports and an
Access Port that can be connected to a
workstation, portable computer, or a modem.
The LGC must use v6.00g or later of the LGM
module driver. For more information, see the
LGM Module Driver document on the
Automated Logic website at
www.automatedlogic.com.
6 1/4"
Figure 1. Module dimensions and layout
and used in accordance with the instruction
manual, may cause harmful interference to
radio communications. Operation of this
equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the
interference at his own expense.
2
Power Switch
Manual Format
Button
Addressing
DIP Switch
CMnet
Connection
1"
© 2000 Automated Logic Corporation
7 1/8"
1 5/8"