HIBLOW HP Series 매뉴얼 - 페이지 9

{카테고리_이름} HIBLOW HP Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIBLOW HP Series 9 페이지.
HIBLOW HP Series에 대해서도 마찬가지입니다: 매뉴얼 (5 페이지), 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (7 페이지)

페이지 인쇄

HP- 100 / 120

STEP

FITTING THE ELECTROMAGNET

Mount new the electromagnets in the unit.

Tighten up nuts with nut driver.

STEP

Install the SP switch to the frame with the screws.

●Be careful of the direction of switch lever. (Refer to the

pictures)

STEP

Insert the wire into the silicon tube, and tie up in a

bundle.

Strip the coating off each wire.

(5-7mm from the end)

Connect the wires to the terminals.

Solder the wires to the terminals.

The wire requires a soldered connection.

STEP

This completes the electromagnet replacement

procedure.

REPLACING THE ELECTROMAGNET