HIBLOW hp-150 사용 설명서 - 페이지 10

{카테고리_이름} HIBLOW hp-150에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIBLOW hp-150 17 페이지. Air pumps
HIBLOW hp-150에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 매뉴얼 (8 페이지)

페이지 인쇄

• Take care not to install the rod with iron particles, screws and other metallic substances attached

on the permanent magnets. Failure to do so can result in damage to the permanent magnets and/

or the electromagnets, or even in a failure of the pump.

��

(8) After the new diaphragm mounting blocks have been installed, install new casing blocks. The

casing blocks can be used again as new if the valves are replaced with new ones. To replace the

valves of the removed casing block with new ones, undo the ﬁve screws of casing A (Exhaust

part side) to remove casing B (Air valve side) and valve chamber cover. (Figs. 15 and 16)

Fig. 15

(9) Pull out four old valves from the casing A using radio pliers, insert each new valve into the center

hole of valve seat while paying attention to the intake and exhaust sides, and pull these valves for

ﬁrm ﬁtting, using radio pliers or other similar means. (Figs. 17 and 18)

CAUTION

��

Screw

Casing Block

��

Fig. 16

Valve chamber packing

Casing B

Casing A