HIBLOW hp-60 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} HIBLOW hp-60에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIBLOW hp-60 7 페이지.
HIBLOW hp-60에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지)

HP- 60/80

！

●Be sure to unplug the pump unit.

●When performing replacement work, the pump body may still be hot and you could

get burned. So please wait until the pump has cooled before handling.

●Be sure to remove the chamber block and the actuating rod before replacing the

electromagnet.

●It is better to let an experienced technician handle the soldering process. Take

precautions against getting burned.

STEP

REMOVAL OF ELECTROMAGNET

Cut the wire from terminals on the electromag-

nets with nippers.

●It is recommended that you make a note of the wiring.

STEP

Loosen the screw, fixing SP switch and remove it .

(There are hexagonal nuts at SP switch side. Be

sure not to lose them as they fall inside the unit.)

STEP

Remove the hexagonal nuts by the nut driver.

(7mm wrench)

Pull out the electromagnets from the pump body.

AUTION

Goodies Wastewater Supplies

Phone: 1300 282 181  Fax: 1300 282 989

PO Box 1524, Oxenford QLD 4210  35 Scenic Cr, Coomera QLD 4209

Email: [email protected]  Web: www.goodies.net.au

REPLACING THE ELECTROMAGNET