Daytona DT125 사용 설명서 - 페이지 5

{카테고리_이름} Daytona DT125에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Daytona DT125 18 페이지. Finger-follower dohc 4valve cylinderhead upgrade kit, engine narrow pitch

페이지 인쇄

2. PISTON / CYLINDER

#5. RING SET, PISTON

#24. PIN, DOWEL 8X12 (2)

#18. GASKET, CYLINDER

#2. CYLINDER

OIL

STOCK

Assemble the piston rings to the piston.

Assemble the piston to the connecting rod.

(Pay attention to the direction.)

Install the dowel pin (8x12mm) into the crankcase.

Set the cylinder gasket and 12mm rubber gasket.

Install the stud bolt to the cylinder.

Be careful not to tighten too tightly.

Caution

！

Do not over tighten or the flatness of the cylinder will be compromised.

If the flatness is compromised, oil leakage may occur.

Apply a generous amount of oil to the cylinder.

Assemble the cylinder,

and then assemble the guide roller (stock).

#4. PISTON

STOCK

#31. BOLT, STUD M6X26

OIL

#6. PIN, PISTON

OIL

#23. GASKET, 12MM RUBBER

10N-m

Do not tighten in this procedure

5~8N-m

"N" MARKING

#31. BOLT, STUD M6X26

80458 PAGE 5/9

#7. CIRCLIP (2)

SPACER RING

RAIL

" Mark indicating

TOP RING

the exhaust side

OIL

2021/06/21