HiBoost F12G-3S-BTW 사용자 설명서 - 페이지 6
{카테고리_이름} HiBoost F12G-3S-BTW에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HiBoost F12G-3S-BTW 13 페이지.
페이지 인쇄2.6 Install the Server (Indoor) antenna
Connect one end of the coaxial cable to the antenna and the other end to the cellular
booster where it is marked "Indoor".
Place in the outer perimeter of the area the signal needs to beamplified.
2.7 Install your cellular booster
Install the cellular booster in a location that is properly ventilated and not exposed to
excessive heat, moisture and/or direct sunlight. The optimal area would be located
near a power outlet.
It should be mounted in an easily accessible area so it's easy to perform general
maintenance with the coaxial cable connections, dip switch settings and power
adaptor.
Make sure all cables and antennas are securely connected before commissioning the
system.
2.8 Power up your cellular booster
Once all the Following precautions have been taken, power on the cellular booster.
1. Verify that you have left at least 0.5meter of vertical separation space between
the indoor and outdoor antennas.
2. Never point the front of the donor (outdoor) antenna towards the inside of the
server (outdoor)antenna.
3. Verify that the supplied coaxial cables from both the donor (outdoor) antenna
and the server (outdoor)antenna are properly connected to the cellular booster
before powering it up.
4. Carefully plug in the supplied power adaptor into the back of the cellular booster
where it is marked 'DC 12~5V' and connect the other end to a power outlet.
The LED indicator marked power should light up blue.
3 UNDERSTAND THE PORTS,and LED STATUS,MGC
3.1 Repeater ports
Connector
Description
Indoor
SMA‐female connector,for connection to indoor antenna
Outdoor
SMA‐female connector,for connection to outdoor antenna
6 / 13