HiBoost Home 10K 사용자 설명서 - 페이지 6

{카테고리_이름} HiBoost Home 10K에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HiBoost Home 10K 20 페이지. Mobile signal booster

commercially available signal strength meter.

We highly recommend that you use the LCD display on the booster as this

method is generally more convenient. However, in situations where the desired

carrier's signal is much weaker than the other local signals, using a mobile

phone, app, or signal level meter can be a more accurate method of homing in

on the best signal for installation.

. LCD Display Method

Connect the outdoor antenna to the booster's outdoor port. Fix the outdoor

antenna on the roof of the building and point it to the nearest cell tower. Then

have a look at the gain and output power value displayed on the booster's LCD.

The outdoor antenna receives the strongest signal when the booster's downlink

output power reaches its highest level in each band. If the LCD shows maximum

gain and power, and there are not any alarms (no ISO, ALC, OFF legend

flashing and no quick flashing green or red in LEDs), it means the present

location is the best for ensuring that the booster has maximized performance.

The maximum downlink power for Home 10K is 12dBm, and the maximum

downlink gain is 62-65dB.

Note: These showed values may vary dynamically at times between 1-3 dB

which is normal due to outdoor signal conditions.

. Mobile Phone Method

You can use a mobile phone to test signal strength on the top of the building. The

number of bars on the network indicator will define approximate strength of the

received signal. Normally the roof of the building is the best place to receive the

strongest signal. As shown on the drawing below, you need to test the signal in

the points from A to E, and select the location with the best signal strength for

outdoor installation. It is recommended to use a mobile app that can display in a

test mode the signal level in dBm units. It is more accurate than checking the

6/18