Dynacut MDM 운영 매뉴얼 - 페이지 15

{카테고리_이름} Dynacut MDM에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynacut MDM 17 페이지. Minimum quantity lubrication system for external lubrication

Switch off the system

The minimum quantity lubrication is set in the reverse order of commissioning.

Close the ball valve for the coolant first (prevents coolant dripping).

Close ball valve for atomizer air.

DYNACUT minimum quantity lubrication systems are low maintenance. However, to ensure

proper operation and to avoid dangers from the start, you should check all connections and

connections regularly.

Cleaning outside:

If necessary, the minimum quantity lubrication system can be cleaned with mild, material-

compatible (not alkaline, no soap) cleaning agents.

For safety reasons, we recommend that the minimum quantity lubrication system be

disconnected from the compressed air and electrical voltage supply and that the container

must be depressurized. When cleaning, connect the hoses as far as possible and close any

openings so that no cleaning agents can penetrate into the interior of the minimum quantity

lubrication system.

Cleaning inside:

In normal operation and when using lubricants which are compatible with each other, an

internal cleaning is not necessary. If an incorrect or dirty lubricant has been accidentally filled,

an internal cleaning of the lubricant reservoir must be carried out.