Dynacut MDM Operation Manual - Page 15

Browse online or download pdf Operation Manual for Lubrication systems Dynacut MDM. Dynacut MDM 17 pages. Minimum quantity lubrication system for external lubrication

Print Page
Dynacut MDM Operation Manual

Switch off the system

The minimum quantity lubrication is set in the reverse order of commissioning.
Close the ball valve for the coolant first (prevents coolant dripping).
Close ball valve for atomizer air.

Maintenance

DYNACUT minimum quantity lubrication systems are low maintenance. However, to ensure
proper operation and to avoid dangers from the start, you should check all connections and
connections regularly.

Cleaning

Cleaning outside:
If necessary, the minimum quantity lubrication system can be cleaned with mild, material-
compatible (not alkaline, no soap) cleaning agents.
For safety reasons, we recommend that the minimum quantity lubrication system be
disconnected from the compressed air and electrical voltage supply and that the container
must be depressurized. When cleaning, connect the hoses as far as possible and close any
openings so that no cleaning agents can penetrate into the interior of the minimum quantity
lubrication system.
Cleaning inside:
In normal operation and when using lubricants which are compatible with each other, an
internal cleaning is not necessary. If an incorrect or dirty lubricant has been accidentally filled,
an internal cleaning of the lubricant reservoir must be carried out.