GreatCo Gallery GBL-44 설치 지침 및 운영 매뉴얼 - 페이지 8
{카테고리_이름} GreatCo Gallery GBL-44에 대한 설치 지침 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GreatCo Gallery GBL-44 8 페이지.
페이지 인쇄In the unlikely event of a problem occurring due to a manufacturing fault within 24 months from the
date of purchase
of the appliance it will be repaired or replaced free of charge.
This warranty does not cover consumable items such as the bulbs and fuses which have a limited
lifespan.
If a problem should occur, the nature of the problem together with the date of a purchase should be
immediately reported to the retailer that the appliance was purchased from. Proof of purchase will
be required so the original receipt should be retained.
Warranty applies to the original owner only and is non-transferrable.
Problem
Fireplace not responding to
remote commands
Fireplace trips circuit breaker or
blows fuse when turned on
Heater is excessively noisy
Odor coming from heater/blower
Flame effect frozen or stuttering
Heater not outputting heat when
turned on.
LED Lighting not turning on
8
WARRANTY
Possible Causes
Switch on fireplace not
in the ON position
Remote control battery
dead or not inserted
properly
Remote is not in range
of fireplace or not aimed
correctly
Improper circuit rating
Too many appliances
plugged into the same
circuit
Blower assembly is dirty
Defective blower
Normal operation
Defective heater
Defective flame motor
Thermal switch tripped
Heater is defective
Thermostat is cycled off
Lighting may be
defective
Solution
Switch must be in the ON position
for remote operation
Insert or check battery for correct
orientation
Move closer to fireplace and aim
remote directly at it.
Ensure unit is plugged into a
dedicated 15 amp circuit
Unplug other appliances on the
same circuit
Unplug unit and clean blower
Blower replacement or repair
necessary
Heater is burning off dust
accumulated during manufacture or
non-use periods. This should only
be noticeable for a brief period after
turning on.
Heater may require replacement or
repair
Flame motor repair or replacement
required.
Turn off unit and unplug for 5
minutes. This is a safety feature to
prevent overheating
Replacement or repair may be
required
Set thermostat to higher setting
Repair or replacement may be
required.