GreatCo Gallery GBL-44 Інструкція з монтажу та інструкція з експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з монтажу та інструкція з експлуатації для Внутрішній камін GreatCo Gallery GBL-44. GreatCo Gallery GBL-44 8 сторінок.

Друкувати сторінку

In the unlikely event of a problem occurring due to a manufacturing fault within 24 months from the

date of purchase

of the appliance it will be repaired or replaced free of charge.

This warranty does not cover consumable items such as the bulbs and fuses which have a limited

lifespan.

If a problem should occur, the nature of the problem together with the date of a purchase should be

immediately reported to the retailer that the appliance was purchased from. Proof of purchase will

be required so the original receipt should be retained.

Warranty applies to the original owner only and is non-transferrable.

Problem

Fireplace not responding to

remote commands

Fireplace trips circuit breaker or

blows fuse when turned on

Heater is excessively noisy

Odor coming from heater/blower

Flame effect frozen or stuttering

Heater not outputting heat when

turned on.

LED Lighting not turning on

WARRANTY

Possible Causes

Switch on fireplace not

in the ON position

Remote control battery

dead or not inserted

properly

Remote is not in range

of fireplace or not aimed

correctly

Improper circuit rating

Too many appliances

plugged into the same

circuit

Blower assembly is dirty

Defective blower

Normal operation

Defective heater

Defective flame motor

Thermal switch tripped

Heater is defective

Thermostat is cycled off

Lighting may be

defective

Solution

Switch must be in the ON position

for remote operation

Insert or check battery for correct

orientation

Move closer to fireplace and aim

remote directly at it.

Ensure unit is plugged into a

dedicated 15 amp circuit

Unplug other appliances on the

same circuit

Unplug unit and clean blower

Blower replacement or repair

necessary

Heater is burning off dust

accumulated during manufacture or

non-use periods. This should only

be noticeable for a brief period after

turning on.

Heater may require replacement or

repair

Flame motor repair or replacement

required.

Turn off unit and unplug for 5

minutes. This is a safety feature to

prevent overheating

Replacement or repair may be

required

Set thermostat to higher setting

Repair or replacement may be

required.