GreatCo GBI-34 주택 소유자 설치 지침 및 운영 매뉴얼 - 페이지 6
{카테고리_이름} GreatCo GBI-34에 대한 주택 소유자 설치 지침 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GreatCo GBI-34 10 페이지. Gallery electric fireplaces
GreatCo GBI-34에 대해서도 마찬가지입니다: 주택 소유자 설치 지침 및 운영 매뉴얼 (11 페이지), 주택 소유자 설치 지침 및 운영 매뉴얼 (11 페이지)
페이지 인쇄Pole
PEGS
MAGNETS
Magnet
1.4 Install the trim onto the insert by locating the pegs on both sides and inserting them into the receiving
clips on the front of the fireplace. Lightly push the trim bottom to fit onto the firebox. The built-in magnets
should hold the front flush. Installation is completed.
Plug the power supply cord into a wall outlet (120Vac, 60Hz).Ensure the plug is inserted into a
properly grounded outlet:
ELECTRICAL CONNECTION
A 15 AMP, 120 Volt, The unit comes standard with 6 feet (1.8 m) three wire cord, exiting from the rear of
the fireplace. Plan the installation to avoid the use of an extension cord. Preferably, the fireplace will be
on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or the
fuse to blow when the heater is in operation.
WARNING:
ALWAYS UNPLUG THE CORD BEFORE MOVING OR SER VICING.
DO NOT IMMERSE HEATER IN WATER!
Always turn OFF the heater and disconnect the cord from the electrical outlet before cleaning your
heater.
Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner.
Wipe the exterior surfaces of the heater occasionally with a slightly damp cloth (not dripping wet) using a
solution of mild detergent and water. Dry the case thoroughly before operating the heater.
Caution: Do not allow water to run into the interior of the heater as this could create a fire or electric shock
hazard.
The fan motor is factory lubricated for life and will not require further lubrication.
Store heater in a clean dry place when not in use.
Warning: Any other servicing needed must be performed by an authorized service representative. Do not
attempt to service the unit yourself.
GROUNDING
MAINTENANCE
6