GreatCo GBI-34 주택 소유자 설치 지침 및 운영 매뉴얼 - 페이지 7

{카테고리_이름} GreatCo GBI-34에 대한 주택 소유자 설치 지침 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GreatCo GBI-34 10 페이지. Gallery electric fireplaces
GreatCo GBI-34에 대해서도 마찬가지입니다: 주택 소유자 설치 지침 및 운영 매뉴얼 (11 페이지), 주택 소유자 설치 지침 및 운영 매뉴얼 (11 페이지)

OPERATING INSTRUCTIONS
This appliance can be operated by both remote control and manual button. Once the unit has been
properly connected
to an earthed electrical outlet, turn on the main power switch located on the left hand side of the
appliance. A beep should be heard when the power is first applied.
CAUTION! The unit's power cord must be connected to a properly grounded and protected
120V outlet. Always use ground fault protection where required by the electrical code.
WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you suspect the
NOTE! To use both remote and manual function. As the main power switch must be in "ON" position.
Operating by Manual Button
NOTE! The manual buttons on the fireplace unit do not operate all functions of this electric fireplace.
Their purpose is to control some basic function if the remote control is misplaced or damaged. Please
use the remote handset to carry out all functions.
Main power switch
The POWER switch supplies power to all of the functions of the fireplace. This switch must be in the
"ON" position for any of the functions including the remote to work.
Flame button
The fire has four flame effects, by pressing the flame effect button the unit will cycle through each effect.
Heater button
Press once turns 750W power on. (Pilot lights illuminated ●○)
Press again turns 1500W power on (Pilot lights illuminated ●●)
Press third time turns heater off. (Pilot lights illuminated ○○)
To Reset the Heater
Your heater includes a protection system that shuts off the heater if it overheats for any reason:
1) Turn unit off.
2) Unplug unit wait 5 minutes.
3) Plug in and turn on.
unit is damaged, please call a qualified service technician to inspect and to
replace any part of the electrical system if necessary.
FLAME
main power switch
flame button
HEATER
heater button
7