GreatCo GBI-34 Інструкція з монтажу та посібник з експлуатації для домашнього користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з монтажу та посібник з експлуатації для домашнього користувача для Внутрішній камін GreatCo GBI-34. GreatCo GBI-34 10 сторінок. Gallery electric fireplaces
Також для GreatCo GBI-34: Інструкція з монтажу та посібник з експлуатації для домашнього користувача (11 сторінок), Інструкція з монтажу та посібник з експлуатації для домашнього користувача (11 сторінок)

OPERATING INSTRUCTIONS

This appliance can be operated by both remote control and manual button. Once the unit has been

properly connected

to an earthed electrical outlet, turn on the main power switch located on the left hand side of the

appliance. A beep should be heard when the power is first applied.

CAUTION! The unit's power cord must be connected to a properly grounded and protected

120V outlet. Always use ground fault protection where required by the electrical code.

WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you suspect the

NOTE! To use both remote and manual function. As the main power switch must be in "ON" position.

●

Operating by Manual Button

NOTE! The manual buttons on the fireplace unit do not operate all functions of this electric fireplace.

Their purpose is to control some basic function if the remote control is misplaced or damaged. Please

use the remote handset to carry out all functions.

Main power switch

The POWER switch supplies power to all of the functions of the fireplace. This switch must be in the

"ON" position for any of the functions including the remote to work.

Flame button

The fire has four flame effects, by pressing the flame effect button the unit will cycle through each effect.

Heater button

Press once turns 750W power on. (Pilot lights illuminated ●○)

Press again turns 1500W power on (Pilot lights illuminated ●●)

Press third time turns heater off. (Pilot lights illuminated ○○)

To Reset the Heater

Your heater includes a protection system that shuts off the heater if it overheats for any reason:

1) Turn unit off.

2) Unplug unit wait 5 minutes.

3) Plug in and turn on.

unit is damaged, please call a qualified service technician to inspect and to

replace any part of the electrical system if necessary.

FLAME

main power switch

flame button

HEATER

heater button