GreatCo GBI-34B 주택 소유자 설치 지침 및 운영 매뉴얼 - 페이지 8

{카테고리_이름} GreatCo GBI-34B에 대한 주택 소유자 설치 지침 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GreatCo GBI-34B 11 페이지.

Screw

ST4x16

1.3 In case that the opening height of mantel is a little

larger, first attach the fixing brackets to the firebox

with ST4x8 screws, then use ST4x16 screws to attach

brackets to the mantle.

Magnet

Magnets

1.5 Install the trim onto the insert by locating the pegs on both sides and inserting them into the receiving clips

on the front of the fireplace. Lightly push the trim bottom to fit onto the firebox. The built-in magnets should hold

the front flush. Installation is completed.

This appliance can be operated by both remote control and manual button. Once the unit has been properly

connected to a grounded electrical outlet, turn on the main power switch located on the bottom and right hand

side of the appliance. A beep should be heard when the power is first applied.

CAUTION!

outlet. Always use ground fault protection where required by the electrical code.

WARNING!

damaged, please call a qualified service technician to inspect and to replace any part of the electrical

system If necessary.

To use both remote and manual function. As the main power switch must be in "ON" position.

NOTE!

Pegs

OPERATING

The unit's power cord must be connected to a properly grounded and protected 120V

Do not operate the unit if it is damaged or has malfunctioned. If you suspect the unit is

Srcrew ST4x8

1.4 Attach the airflow plate to the firebox with ST4x8

screws.

Airflow plate