GreatCo GBI-34B Ev Sahibinin Kurulum Talimatları ve Kullanım Kılavuzu - Sayfa 8

Kapalı Şömine GreatCo GBI-34B için çevrimiçi göz atın veya pdf Ev Sahibinin Kurulum Talimatları ve Kullanım Kılavuzu indirin. GreatCo GBI-34B 11 sayfaları.

Sayfayı Yazdır
Screw
ST4x16
1.3 In case that the opening height of mantel is a little
larger, first attach the fixing brackets to the firebox
with ST4x8 screws, then use ST4x16 screws to attach
brackets to the mantle.
Magnet
Magnets
1.5 Install the trim onto the insert by locating the pegs on both sides and inserting them into the receiving clips
on the front of the fireplace. Lightly push the trim bottom to fit onto the firebox. The built-in magnets should hold
the front flush. Installation is completed.
This appliance can be operated by both remote control and manual button. Once the unit has been properly
connected to a grounded electrical outlet, turn on the main power switch located on the bottom and right hand
side of the appliance. A beep should be heard when the power is first applied.
CAUTION!
outlet. Always use ground fault protection where required by the electrical code.
WARNING!
damaged, please call a qualified service technician to inspect and to replace any part of the electrical
system If necessary.
To use both remote and manual function. As the main power switch must be in "ON" position.
NOTE!
Pegs
Pin
OPERATING
The unit's power cord must be connected to a properly grounded and protected 120V
Do not operate the unit if it is damaged or has malfunctioned. If you suspect the unit is
Srcrew ST4x8
1.4 Attach the airflow plate to the firebox with ST4x8
screws.
7
Airflow plate