DaytonAudio HTA200BT 사용자 설명서 - 페이지 7

{카테고리_이름} DaytonAudio HTA200BT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DaytonAudio HTA200BT 12 페이지. 200w integrated stereo hybrid tube amplifier

Connecting Speakers

The amplifier can power speakers with a minimum impedance of 4Ω. Using high quality two conductor speaker wire

connect your speakers to the binding posts on the rear of the unit.

Connect the HTA200's left speaker terminals marked "L-" and "L+" to the corresponding "-" and "+" terminals on your

left speaker. Repeat the same process for the right channel.

Note: Never connect the negative terminals together or to ground. The HTA200 is not designed to operate in a

bridged mode and attempting to do so may damage the amplifier.

1. Tighten the knob.

2. Insert the banana plug terminated cable into the

end of the corresponding terminal.

If you really want to feel the bass or just want to bother the neighbors you can add a subwoofer using the SW OUT

connection on the rear of the HTA200. This signal is full range and will send a mono summed signal that is control-

lable by the front volume knob. Using a single RCA cable you can connect to the line level input on a powered sub-

woofer or to any external subwoofer amplifier to power passive subwoofers.

Headphones can be connected to the ¼" TRS connection on the front of the HTA200. This is great for listening to any

source and enjoying the classic warmth from the tube preamps. Plugging in headphones will stop any signal from

being output to the speaker output terminals or SW OUT.

Note: To avoid damage to headphones or your hearing make sure to turn down the volume before plugging in your

headphones. Always turn down the volume knob before unplugging headphones to avoid accidental output to your

speakers or startling any cats napping nearby.

1. Strip about 3/8" of insulation from the end of each

speaker wire and twist the bare wires of the cable

together.

2. Unscrew the knob before inserting the bare wire into

the hole in the side of each terminal before tightening

the knob to secure the wire.