Automatic Solutions 603STD 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} Automatic Solutions 603STD에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Automatic Solutions 603STD 12 페이지.

Please read this entire manual before attempting to install this system.

This system should only be installed by a professional automatic gate installer or access control

specialist installer.

It is recommended that the system be range tested on site BEFORE being fully installed.

Before installing this system, you need to be sure that the range of the system will be sufficient.

The transmitter and speech unit can be powered up, call button pressed, and then check that the

handset will ring from all areas in which it will be used.

Up to 200m / yards

Speech

panel

Tip: For longer range installations, locate the handset close to the front of the property, near a

window if possible. Concrete walls can reduce the open-air range of 400 metres/yards by 30-50%

per wall.

CAUTION!

Competent person only!

24v dc PSU

TIP: Most technical calls received are due to installers using CAT5 or alarm cable to power

the unit. Neither are rated to carry enough power (1.2 amp peak). Please use following

cable...

Up to 2 metres (6 feet) – Use minimum 0.5mm

Up to 4 metres (12 feet) – Use minimum 0.75mm

Up to 8 metres (24 feet) – Use minimum 1.0mm

P a g e

| 3

Overview of System

Power cable (2x1mm / 16 gauge)

Transmitter

Intercom

Transmitter

603 Range

Keep high!

(20 gauge)

(18 gauge)

(16 gauge)

Walls causing weak signal

Speech

point

Screened CAT5

Keep short as

possible!