GAI-Tronics 354-001 series 사용자 설명서 - 페이지 3

{카테고리_이름} GAI-Tronics 354-001 series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GAI-Tronics 354-001 series 12 페이지. Nema 4x industrial telephone

Pub. 42004-489D

Model 354-001 Series NEMA 4X Industrial Telephone

Page 3 of 10

Installation

WARNING

This product can contain hazardous voltages. Always remove power to this

station and any associated equipment before beginning any installation.

CAUTION

Do not install this equipment in areas other than those indicated on the

approval listing in the "Specifications" section of this manual. Such installation may cause a safety

hazard and consequent injury or property damage.

Install equipment without modification and according to all applicable local and national electrical codes.

Consult the National Electrical Code (NFPA 70), Canadian Standards Association (CSA 22.1), and local

codes for specific requirements regarding your installation. Class 2 circuit wiring must be performed in

accordance with NEC 725.55.

Security Hardware

The Model 354-001 series Telephone is vandal-resistant, with the front panel attached to its enclosure

with security screws. A GAI-Tronics Model 233-001 Security Screwdriver (sold separately) or Torx T-

25 security head tip (included with the telephone) is recommended for installing the security screws.

GAI-Tronics recommends installing telephone cable in conduit to protect against damage and vandalism.

Mounting and wiring of the Model 354-001 series Telephones must be in accordance with installation

standard practices.

Entering the enclosure from the top is not recommended. Bottom (preferred) or side entry helps prevent

condensation moisture from dripping onto the telephone electronics causing severe damage. If using

conduit, an appropriate hub (Myers STG series recommended) or a UL Listed NEMA 4X rated connector

appropriate for the installation should be used. If a top entry must be made, a drip path is strongly

recommended. Seal all conduit entrances around the entry point and inside the conduit using a silicone-

type sealant.

The Model 354-001 series Telephones are not supplied with openings for conduit or cable because of

potential installation variations. Conduit entrances must be installed prior to mounting the enclosure to

the wall surface.

1. Open the door and remove the front panel assembly (carefully set aside).

2. Drill (hole saw) or punch entry openings using the template provided with the telephone. There must

be a minimum of 1 inch (26 mm) of material between entry holes.

3. Install hub or fitting.

f:\standard ioms - current release\42004 instr. manuals\42004-489d.doc

01/15