DynaGen GSC400 Series 프로그래머 매뉴얼 - 페이지 2

{카테고리_이름} DynaGen GSC400 Series에 대한 프로그래머 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DynaGen GSC400 Series 4 페이지. For generator
DynaGen GSC400 Series에 대해서도 마찬가지입니다: 캘리브레이션 유틸리티 매뉴얼 (18 페이지)

페이지 인쇄

Getting Started.

Your package should include the following:

1. GSC400 Programmer

2. 10 pin ribbon cable female-to-female

3. Two male-to-male 10pin headers

4. USB printer cable

5. Serial DB-9 cable

6. Installation CD

The GSC400 programming board

consists of a USB-B type connector

(the one usually found on printers,

not the more common A-type

connector that you plug into your

computer), a serial DB-9 female

cable, a programmer port, one push

button, and one slide switch.

The USB and serial cables are used

to connect the GSC400 programmer to the computer. Both are provided as a convenience and

only one should be connected to the board.

The 10 pin ribbon cable plugs into the programming port, red stripe facing the push button. The

other end of the ribbon cable plugs into the controller with the

red stripe facing the center of the unit. The two 10 pin male-to-

male headers plug into the ribbon cable as shown in the diagram.

GSC400 Programmer Manual

Revision 1.0 (22/12/2006)

10 pin Ribbon