DynaGen GSC400 Series Handleiding voor programmeurs - Pagina 2
Blader online of download pdf Handleiding voor programmeurs voor {categorie_naam} DynaGen GSC400 Series. DynaGen GSC400 Series 4 pagina's. For generator
Ook voor DynaGen GSC400 Series: Handleiding voor kalibratiehulpprogramma (18 pagina's)
Pagina afdrukken
Getting Started.
Your package should include the following:
1. GSC400 Programmer
2. 10 pin ribbon cable female-to-female
3. Two male-to-male 10pin headers
4. USB printer cable
5. Serial DB-9 cable
6. Installation CD
The GSC400 programming board
consists of a USB-B type connector
(the one usually found on printers,
not the more common A-type
connector that you plug into your
computer), a serial DB-9 female
cable, a programmer port, one push
button, and one slide switch.
The USB and serial cables are used
to connect the GSC400 programmer to the computer. Both are provided as a convenience and
only one should be connected to the board.
The 10 pin ribbon cable plugs into the programming port, red stripe facing the push button. The
other end of the ribbon cable plugs into the controller with the
red stripe facing the center of the unit. The two 10 pin male-to-
male headers plug into the ribbon cable as shown in the diagram.
GSC400 Programmer Manual
Revision 1.0 (22/12/2006)
10 pin Ribbon
2