Hickok WAEKON FPT2600 사용자 설명서 - 페이지 10

{카테고리_이름} Hickok WAEKON FPT2600에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hickok WAEKON FPT2600 16 페이지. I/m handheld fuel cap test system

Connecting & Using the Tester

Before You Begin

• Please read the instructions carefully before using the tester. Failure

to follow the instructions may cause incorrect test results.

• Before using the tester for the first time, remove the battery

protector pull tab.

• Make sure the vehicle is turned off before removing the fuel cap.

• When removing the fuel cap, do so slowly and allow any pressure to

decay before fully removing the cap.

• Because residual pressure from a previous test will cause an

incorrect auto zero, never power up the tester with the fuel cap

connected to the adapter.

Step 1—Check the Tester's Flow Rate Calibration

Always check the tester's flow rate calibration before initial use for

certified vehicle testing and before testing begins each day. Failure to

check the tester's calibration may cause inaccurate test results. There are

two parts to this test—one with the swing valve set to Pass, and the other

with the valve set to Fail.

• Do not attach the Pass/Fail Standard to the tester until after the

power is on.

• Install the Pass/Fail Standard and start the test as soon as possible

after auto zero.

If testing is not started within one minute after auto zero, the tester

will shut itself off. If this happens, repeat the instructions for the

calibration test from the beginning.

• Do not disturb (turn or press) the Pass/Fail Standard during pumping

and testing.

IMPORTANT! If the Flow Rate Calibration Check fails, do not use the

tester for certified testing. Contact Waekon Customer Service for

technical assistance.

10 FPT2600-EX1 User Guide