GAI-Tronics DEX-201 매뉴얼 - 페이지 7

{카테고리_이름} GAI-Tronics DEX-201에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAI-Tronics DEX-201 14 페이지. Hazardous area driller’s intercom stations

페이지 인쇄
M
DEX-10
DEX-20
ODEL
X AND

Field Wire Installation

Remove the termination enclosure cover and pull all wiring into the termination enclosure. Make all
connections as described below.
: All field wiring is to be completed in the termination enclosure (bottom enclosure) only.
N
OTE
Figure 4. DC Model Installation Diagram (See note below.)
Figure 5. AC Model Installation Diagram (See note below.)
: Consult the National Electrical Code (NFPA 70), Canadian Standards Association (CSA 22.1),
N
OTE
and local codes for the specific requirements regarding your installation. Install all equipment without
modification and according to the local and national codes. Install conduit and seals where required.
Class 2 circuit wiring must be performed in accordance with NEC 725.55.
f:\standard ioms - current release\42004 instr. manuals\42004-679l2d.doc
10/10
D
'
I
S
X
RILLER
S
NTERCOM
TATIONS
Pub.: 42004-679L2D
Page 6 of 13