AirCycler g1 설치 및 사용 설명서 - 페이지 6

{카테고리_이름} AirCycler g1에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AirCycler g1 11 페이지. Ventilation controller
AirCycler g1에 대해서도 마찬가지입니다: 설치 테스트 매뉴얼 (2 페이지)

페이지 인쇄

2.0 CALCULATED FLOW SET UP

2.1 SETTING MEASURED SUPPLY AIR FLOW

The measured flow is the amount of air that enters the

return side of the air handler from the outside air vent.

Enter the measured flow. To accommodate variable speed

air handlers, you can enter different values for heat, cool

and fan. Factory default is 90 CFM.

Press MODE to advance to the next setting.

2.2 SETTING CODE REQUIRED CONSTANT AIR FLOW

Set the required continuous air flow in CFM based on relevant codes. For ASHRAE 62.2

see Appendix A. Factory default is 30 CFM. The AirCycler® g1 will calculate run times

based on settings 2.1 and 2.2.

Press MODE to advance to the next setting

2.3 SETTING OPTIONAL MIXING TIME

If the user needs more central fan time for whole house mixing than the amount that

is provided by ventilation time, the central fan can be configured to run an additional

time period to complete the mixing period. Factory default is 0 or OFF. To use/change

this setting press UP arrow. The fresh air damper will not be open during this extra time.

Press MODE to advance to next setting.

2.4 SETTING OPERATION HOURS

If the user does not want the ventilation system to run throughout the day you can set

ON time and OFF time. Factory default is NO. If you are not setting an ON and OFF time,

press MODE and continue to section 2.5.

If you want to set hours of operation press the UP arrow for yes [YS]. Press MODE to select

yes. The AirCycler® g1 will prompt you to enter the hour you would like the ventilation

to begin and the hour you want it to end followed by the current time.

Set the hour you want ventilation to START. Press MODE to advance to the next setting.

Set the hour you want the ventilation to STOP. Press MODE to advance to next setting.

2.4.1 SETTING CURRENT TIME

Enter the current time. Press MODE to save all settings. Setup is complete.

2.5 CALCULATED FLOW SETUP IS COMPLETE

Set up is complete. The AirCycler® g1 will now return to normal operation.

Flow measured

during heat call

Flow measured during

cooling call

Flow measured during

fan only call

*Only if FanConnect™ switch is not

connected

Alternating

Display

Press: MODE

Alternating

Display

Press: MODE

Alternating

Display

Press: MODE

AC DOC

REV 9/14/2016