Automation Correct Coal-trol Digital TS2 V3 사용 설명서 - 페이지 5

{카테고리_이름} Automation Correct Coal-trol Digital TS2 V3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Automation Correct Coal-trol Digital TS2 V3 16 페이지.

Instruction Manual

Locating the Thermostat

The room temperature sensor is located in the Thermostat. For proper

operation, the sensor must be exposed to the heat produced by the

stove. The preferred mounting locations include: An inside wall, away

from the direct air stream of the convection blower, and away from

radiant heat produced by the stove. The Thermostat does not have to

be within the same room as the stove if air readily circulates to the

location of the Thermostat.

Connect the Motor Cords to the Control Module

On Coal-trol systems with plug cords, match the color coded power

cords with the corresponding plug cords. On other models, identify the

appliance motors and plug into the corresponding outlets on the Control

Module. NOTE: A qualiﬁed HVAC Technician should be used to adapt

the appliance to the control module. For more information see our

website.

Connect Thermostat to Control Module

Connect the Thermostat cable to the THERMOSTAT connector on the

Control Module and the Connector on the rear of the TS2 Thermostat.

Push connectors in until you hear it click.

The provided 25 ft. cord may be extended up to 100 ft. with an eight

pin, RJ45 to RJ45 coupler and/or standard computer network cable.

The cable must be a 'through' type, not a crossover type. Note: The

Coal-trol thermostat and Power Module cannot be connected to

computer networks through this cable.

Power On/Off

Power to the Coal-trol system is controlled by the On/Off switch on the

Control Module. When illuminated the control is on. Power to the

thermostat is always on when the control module is plugged in and has

power.

Automation Correct LLC

Coal-trol Digital™ - Model TS2 V3

25 ft. Thermostat Cord

5/2010 R0

Page 5