Dynalink RTA770 빠른 설정 매뉴얼 - 페이지 13

{카테고리_이름} Dynalink RTA770에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynalink RTA770 16 페이지. Adsl router/modem

Troubleshooting

Q1. Cannot open the router control panel from my browser.

1. Check that the router's LAN (or USB) light is on. If not, check your Ethernet

(or USB) cable.

2. Perform a PING test. Go to Start–Programs–MS DOS/Command Prompt (In

Windows XP or 2000 you may click Start-Run. Enter cmd then OK). Type ping

192.168.1.1 then press Enter. The response should be:

Pinging 192.168.1.1 with 32 bytes of data:

Reply from 192.168.1.1: bytes=32 time=4ms TTL=30

....

If you see a similar response, the router is communicating with your computer

correctly and the problem lies elsewhere. If the result is Request timed out

or similar failures, there may be a networking problem. Check that the LAN

or USB cable is firmly plugged in.

3. Disable any personal firewall or virus checker temporarily. If you are using

Internet Explorer, go to Tools–Internet options-Security. Reset security level

of all 4 icons to default. You can revert to your customised settings after

configuring the router.

4. If previously the computer had a dialup modem, check browser setting. For

example in Internet Explorer, go to Tools–Internet options–Connections, and

select Never dial a connection. Also check LAN Settings that the option Use

a Proxy Server is not selected.

5. If the router is connected to a network hub, try connecting the router directly

to the computer in a standalone setup to eliminate any possible problem

associated with the hub.

6. The router's private IP address is 192.168.1.1. To access the browser control

panel your computer must be on the same subnet as the router. See also Q3.

Q2. Cannot connect to Internet or cannot browse

1. Check router's DSL light is on. Normally it takes less than one minute to

establish a link with the telephone exchange. The link will establish as long

as there is signal. If the DSL light does not come on the router is not seeing

any signal. Check that:

ADSL service has been enabled.

If there is a designated ADSL jackpoint for the service, make sure the router

is connected directly into this jackpoint. Other jackpoints cannot be used.