Dynalink RTA770 Руководство по быстрой настройке - Страница 13
Просмотреть онлайн или скачать pdf Руководство по быстрой настройке для Сетевой маршрутизатор Dynalink RTA770. Dynalink RTA770 16 страниц. Adsl router/modem
Печатать страницу10
Troubleshooting
Q1. Cannot open the router control panel from my browser.
1. Check that the router's LAN (or USB) light is on. If not, check your Ethernet
(or USB) cable.
2. Perform a PING test. Go to Start–Programs–MS DOS/Command Prompt (In
Windows XP or 2000 you may click Start-Run. Enter cmd then OK). Type ping
192.168.1.1 then press Enter. The response should be:
Pinging 192.168.1.1 with 32 bytes of data:
Reply from 192.168.1.1: bytes=32 time=4ms TTL=30
....
If you see a similar response, the router is communicating with your computer
correctly and the problem lies elsewhere. If the result is Request timed out
or similar failures, there may be a networking problem. Check that the LAN
or USB cable is firmly plugged in.
3. Disable any personal firewall or virus checker temporarily. If you are using
Internet Explorer, go to Tools–Internet options-Security. Reset security level
of all 4 icons to default. You can revert to your customised settings after
configuring the router.
4. If previously the computer had a dialup modem, check browser setting. For
example in Internet Explorer, go to Tools–Internet options–Connections, and
select Never dial a connection. Also check LAN Settings that the option Use
a Proxy Server is not selected.
5. If the router is connected to a network hub, try connecting the router directly
to the computer in a standalone setup to eliminate any possible problem
associated with the hub.
6. The router's private IP address is 192.168.1.1. To access the browser control
panel your computer must be on the same subnet as the router. See also Q3.
Q2. Cannot connect to Internet or cannot browse
1. Check router's DSL light is on. Normally it takes less than one minute to
establish a link with the telephone exchange. The link will establish as long
as there is signal. If the DSL light does not come on the router is not seeing
any signal. Check that:
ADSL service has been enabled.
If there is a designated ADSL jackpoint for the service, make sure the router
is connected directly into this jackpoint. Other jackpoints cannot be used.