HID FARGO DTC II 유지 관리 매뉴얼 - 페이지 7

{카테고리_이름} HID FARGO DTC II에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HID FARGO DTC II 11 페이지.

Powering

Trusted Identities

2.1 Adhesive cleaning card routine

Video link:

https://player.vimeo.com/video/679193087

The following diagram shows the location where the cleaning card is inserted into the printer.

1. Remove all cards from the card hopper.

2. Take out the ribbon cartridge and set it aside. Close the door.

3. Remove the paper backing from both sides of the cleaning card.

Note: Do not remove small liner strip, if a magnetic encoding module is installed in your printer.

4. Insert the cleaning card into the in-feed rollers of the card hopper.

5. Navigate through the onscreen menu to the Toolbox and select Clean Printer.

6. Guide the cleaning card into the printer, if necessary.

7. When the cleaning routine is completed, the cleaning card exits the printer.

8. Discard the cleaning card as it is a one-time use item.

9. Re-install the ribbon.

10. Re-install all cards that were removed.

PLT-06335, A.0

HID® FARGO® DTC™ii and DTCii Plus

Recommended Maintenance

February 2022