Gainlab Audio GLA-TC2 캘리브레이션 매뉴얼 - 페이지 10

{카테고리_이름} Gainlab Audio GLA-TC2에 대한 캘리브레이션 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gainlab Audio GLA-TC2 18 페이지.
Gainlab Audio GLA-TC2에 대해서도 마찬가지입니다: 매뉴얼 (13 페이지)

페이지 인쇄
Gainlab Audio GLA-TC2 캘리브레이션 매뉴얼
Now go back to 3.3 and check if in Bypass mode you still measure 0V in between TP4 and TP5.
Most likely it will stay as you set up earlier. Repeat 3.3 and 3.4 if needed.
4.
STEP - LEVELLING
Starting point:
Input signal: +0dBu 1kHz sinewave, on both channels
Mode-HiComp, Meter- Output meter, Threshold
Switch positions:
minimum (full left), UNLINK
Measurement process: Adjust: VR1
Target: to measure +0.05dBu on the left output of the unit (not the
VU meter!)
Adjust: VR2
Target: to measure +0.05dBu on the right output of the unit
(not the VU meter!)
Error margin: 0.1dBu