Gree 13-04710 소유자 매뉴얼 - 페이지 9
{카테고리_이름} Gree 13-04710에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gree 13-04710 18 페이지. Window air conditioner
페이지 인쇄
AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the best possible results. This sec-
tion explains proper air conditioner operation.
IMPORTANT:
If you turn off the air conditioner, wait at least 3 minutes before turning it back on. This pre-
vents the air conditioner from blowing a fuse or tripping a circuit breaker.
Do not operate your air conditioner in the cooling mode when outside temperature is
below 16°C (61 °F ). The inside evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTE: In the event of a power failure, your air conditioner will operate at the previous settings
when the power is restored.
About the controls on the air conditioner—models with touch pads.
Features and appearance will vary. Lights next to the touch pads on the
air conditioner control panel indicate the selected settings.
NOTE: The display always shows
the room temperature except when
setting the temperature or the
delay timer.
Light indicates the unit is in the
temperature or delay time Set mode.
Light indicates the delay timer is set.
Air Conditioner Controls
Controls
Power Pad ( )
Turns air conditioner on and off. When
turned on, the display will show the room
temperature.
Display
Shows the room temperature or time
remaining on the Delay timer. Shows the
temperature while setting the temperature in
Cool
Energy Saver
or
modes. The
turn on while setting.
T
e
m
p
n I
r c
a e
e s
D /
e
r c
a e
e s
Use to set temperature when in
Energy Saver
mode. The Set light will turn
setting.
on while
Delay 1–24hr
Delay timer Decrease
Mode select
Fan speed Decrease
Temperature set
Increase and Decrease
Delay Timer Increase
Pads
Each touch of the
pads on the unit or the Increase +/ Decrease–
pads on the remote control will set the delay
time when using the
Set
Set
The
light will turn on while setting.
Fan Speed Pads
Set
light will
Use to set the fan speed to
Auto
or
on the unit.
P
a
s d
control, use the fan speed
Cool
or
+
Decrease –
Low , Med
Auto
fan on.
12
YK4EB
Delay timer Increase
Auto Fan on
Fan speed Increase
Unit power on/off
Remote Control
(+) /Decrease
Increase
/ Decrease
Delay 1–24hr
timer (
Low , Med , High
NOTE:
On the remote
Increa se
/
pads to set the fan speeds to
High
Auto
or
. Use the
(–)
).
pad to turn