AFG 2.0AS Assembly and 조립 및 사용 설명서 - 페이지 8
{카테고리_이름} AFG 2.0AS Assembly and에 대한 조립 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AFG 2.0AS Assembly and 15 페이지. Afg series
AFG 2.0AS Assembly and에 대해서도 마찬가지입니다: 조립 및 사용 설명서 (16 페이지)
페이지 인쇄
AS SE MB LY ST EP
HARDWARE BAG CONTENTS :
CLEVIS
BALL STOP
WASHER
"O" RING
NUT
WASHER
HOOK
HANDLE
HANDLE
RADIAL
ARM ASSEMBLY
A
Open HARDWARE BAG .
B
Remove NUT, WASHERS, SCREW, HOOK, CLEVIS and BALL STOP from one end of CABLE B.
C
Route CABLE B through the pulley system in the RADIAL ARM ASSEMBLY as shown in
diagram.
NOTE: Thread cable through SINGLE FLOATING PULLEY between each arm of the RADIAL
ARM ASSEMBLY.
D
After CABLE B routing is complete replace BALL STOP, CLEVIS, HOOK, SCREW, WASHERS
and NUT on end of cable.
NOTE: Ensure the "O" RINGS are positioned at the ends of CABLE B against the BALL
STOPS.
E
Hook HANDLES on to cable using the 2 HOOKS.
1
2.0AS_Rev.1.5.indd 14-15
CABLE B
Qty: 1
SINGLE FLOATING
PULLEY BRACKET
CABLE B
SCREW
ASSEMBLY STEP
HARDWARE BAG CONTENTS :
"O" RING
BALL STOP
CABLE B
CLEVIS
WASHER
NUT
HOOK
LAT BAR
A
Open HARDWARE BAG .
B
Remove NUT, WASHERS, SCREW, HOOK, CLEVIS and BALL STOP from one end of CABLE C.
C
Install CABLE C as shown in diagram. Ensure that the SINGLE FLOATING PULLEY BRACKET
is installed after passing through two upper pulleys.
D
After CABLE C routing is complete replace BALL STOP, CLEVIS, HOOK, SCREW, WASHERS
and NUT on end of cable.
NOTE: Ensure the "O" RINGS are positioned at the ends of CABLE C against the BALL
STOPS.
E
Install lat bar using the 2 HOOKS.
CABLE C
Qty: 1
WASHER
UPPER PULLEY
SCREW
ASSEMBLY
LAT BAR
SINGLE FLOATING
PULLEY BRACKET
CABLE C
1
9/23/08 10:14:56 AM