AFG 2.0AS Assembly and Montaj ve Kullanım Kılavuzu - Sayfa 8
Ev Spor Salonu AFG 2.0AS Assembly and için çevrimiçi göz atın veya pdf Montaj ve Kullanım Kılavuzu indirin. AFG 2.0AS Assembly and 15 sayfaları. Afg series
Ayrıca AFG 2.0AS Assembly and için: Montaj ve Kullanım Kılavuzu (16 sayfalar)
Sayfayı Yazdır
AS SE MB LY ST EP
HARDWARE BAG CONTENTS :
CLEVIS
BALL STOP
WASHER
"O" RING
NUT
WASHER
HOOK
HANDLE
HANDLE
RADIAL
ARM ASSEMBLY
A
Open HARDWARE BAG .
B
Remove NUT, WASHERS, SCREW, HOOK, CLEVIS and BALL STOP from one end of CABLE B.
C
Route CABLE B through the pulley system in the RADIAL ARM ASSEMBLY as shown in
diagram.
NOTE: Thread cable through SINGLE FLOATING PULLEY between each arm of the RADIAL
ARM ASSEMBLY.
D
After CABLE B routing is complete replace BALL STOP, CLEVIS, HOOK, SCREW, WASHERS
and NUT on end of cable.
NOTE: Ensure the "O" RINGS are positioned at the ends of CABLE B against the BALL
STOPS.
E
Hook HANDLES on to cable using the 2 HOOKS.
1
2.0AS_Rev.1.5.indd 14-15
CABLE B
Qty: 1
SINGLE FLOATING
PULLEY BRACKET
CABLE B
SCREW
ASSEMBLY STEP
HARDWARE BAG CONTENTS :
"O" RING
BALL STOP
CABLE B
CLEVIS
WASHER
NUT
HOOK
LAT BAR
A
Open HARDWARE BAG .
B
Remove NUT, WASHERS, SCREW, HOOK, CLEVIS and BALL STOP from one end of CABLE C.
C
Install CABLE C as shown in diagram. Ensure that the SINGLE FLOATING PULLEY BRACKET
is installed after passing through two upper pulleys.
D
After CABLE C routing is complete replace BALL STOP, CLEVIS, HOOK, SCREW, WASHERS
and NUT on end of cable.
NOTE: Ensure the "O" RINGS are positioned at the ends of CABLE C against the BALL
STOPS.
E
Install lat bar using the 2 HOOKS.
CABLE C
Qty: 1
WASHER
UPPER PULLEY
SCREW
ASSEMBLY
LAT BAR
SINGLE FLOATING
PULLEY BRACKET
CABLE C
1
9/23/08 10:14:56 AM