Hiddn KryptoDisk 2 사용자 설명서 - 페이지 5

{카테고리_이름} Hiddn KryptoDisk 2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hiddn KryptoDisk 2 17 페이지. Selfkey model
Hiddn KryptoDisk 2에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (2 페이지), 사용자 설명서 (16 페이지)

페이지 인쇄

2. First time use

This section contains instructions on how to set up the KryptoDisk 2 during first use. Before you can start using

the KryptoDisk 2, you must initialize (i.e. pair) the device and the user primary card (included), and format the

hard drive from your computer's operating system.

Unlike most other drives on the market, Hiddn's two-factor encryption products cannot be pre-formatted. This

is a security feature and a consequence of how the encryption module inside the KryptoDisk 2 is designed.

When you pair the KryptoDisk 2 with the user primary card, the data encryption key is transferred to the device

for the first time. That means that any pre-installed data (e.g. partition tables) would be unreadable. To be able

to use the KryptoDisk 2 with your computer, the KryptoDisk 2 therefore needs to be formatted upon first use.

When the KryptoDisk 2 is initialized and formatted, it is ready to be used with your preferred device.

Initialize the KryptoDisk 2 encryption module

1. Insert the user primary card in your KryptoDisk 2

2. Connect the device to your computer using the included USB cable

3. The device will prompt you to confirm initialization using the user primary card. Press the "9"-key followed

by the '#'-key to confirm.

4. Enter your PIN, do not unplug device.

5. Wait until the device prompts you to restart, then unplug the device from your computer

6. Connect the device to your computer again with the user primary card still inserted

7. The device will prompt you to enter a PIN code. The code can be found on the PIN/PUK card included with

the user primary and user data restore cards

The device is now initialized and successfully paired with the user primary card. Please note that if you insert

the user data restore card from this point onward, the user primary card will be invalidated, and you will have

to order a new set of cards.

Please contact

[email protected]

Initialize and format the KryptoDisk 2 hard drive

Before you can start using the KryptoDisk 2, the hard drive must be initialized and formatted. For instructions

on this step, please refer to section 9Error! Reference source not found..

Change PIN code

We strongly recommend that you change the pre-set PIN code. For instructions on this step, please refer to

section 8 - Admin menu.

KRYPTODISK 2 |

for purchasing new cards.

USER PRIMARY AND DATA RESTORE CARD