Hideaway Beds Beta Bed Single 조립 지침 매뉴얼 - 페이지 18
{카테고리_이름} Hideaway Beds Beta Bed Single에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hideaway Beds Beta Bed Single 20 페이지. Wallbed frame and cabinet system
페이지 인쇄STEP 7: Install the Bed Face Panel in Cabinet (cont.)
6.
Stand the Bed Face Panel on the Head end and align it just in front of the Tension
arms. Gently (do not bump the Torsion Arms) work the Side Rails into position
between the Torsion Arms. Carefully lift the Bed Face Panel approximately 4"
(100mm) or enough for the 5/16" (8mm) bolt loosely secured in hole #3 to drop into
the slot on the end of the Tension Arm. Repeat this procedure on both sides of the
Bed Face Panel.
7.
Tilt the Bed Face Panel out until the arm locks disengage and the Allen socket head
bolt head, in hole #1, is seated in the notch at the bottom of the tension arm. Tighten
the 5/16" (8mm) bolts in holes #3 securely.
8.
Install the 5/16" (8mm) bolts in holes #2 and securely tighten. Let the Bed Face Panel
close gently. Do not let it slam shut. Damage can be caused by slamming - especially
if the mattress is not in place.
9.
ALERT: Place the mattress across the Bed Face Panel so it will not slam shut. If this
is not possible, your assistant must hold the panel down.
Side Panel
Drawing 14.
Bed Panel
Face
Head of Bolt
in Hole #3
Bolt Hole #2
Allen Bolt in
Hole #1
Side Panel
Bolt Hole #2
Allen Bolt in
Hole #1 seated
in notch
Drawing 15.
Bed Panel
Unit Rail
Bolt Hole #3
seated in slot
18.