DB Research EUPHORIA EPS8 사용자 설명서 - 페이지 2
{카테고리_이름} DB Research EUPHORIA EPS8에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DB Research EUPHORIA EPS8 8 페이지. 8-inch low profile amplified subwoofer
페이지 인쇄Panel controls and features
A.POWER STATUS LED
This bi-color LED glows green when power is
on and no problems are present. If one of the
protection circuits comes on, it will change to
red.
B.PHASE SHIFT
Use this switch to help compensate for time
alignment problems in the system. Such
problems usually result from having the
subwoofer at a different distance from the
listener than the other speakers in the system.
C.AUTO POWER ON
The AUTO POWER ON(ON/OFF) is for high
level(speaker-level) connections. When the
switch is in the "ON" position, the subwoofer
will AUTO POWER ON when there is signal
input. If the amplifier detects no signal input,
the amplifier will auto power off. If you prefer
to use the remote turn on/off connection,
leave switch in the "OFF" position.
D.LOW PASS FILTER
T
his control alows you fine tune the frequency
range you want the subwoofer amplifier will
receive.
E.BASS BOOST
T
he BASS BOOST feature will increase the
sound level in the bass frequencies.
F.INPUT GAIN CONTROL
After you have installed your system, turn this
control to minimum.
Turn the head unit on (and the subwoofer will
turn on via the remote connection). Turn the
head unit volume to about 2/3 full level.
Slowly turn up the subwoofer input gain control
until you hear a small amount of distortion. Then
reduce the level until the distortion is completely
gone. Level the control at this setting.
G.REMOTE LEVEL CONTROL
Attach the included remote level control to
control the volume level of the subwooer
independently.
H.HIGH LEVEL (speaker level) INPUTS
If your head unit does not have RCA outputs
you can use the speaker outputs for the audio
source for the subwoofer. Use the supplied
cable and wire harness and connect the
outputs properly as shown in the connection
diagram in this manual.
I.LOW LEVEL RCA INPUTS
If RCA outputs are present on your head unit
Low level inputs are the recommended way
to introduce the audio signal into your subwoofer.
J.FUSE
Do not use a fuse with a different value
other than the origional value.
K.POWER INPUT TERMINAL
1