Celestron NexStar 130SLT 빠른 설정 매뉴얼 - 페이지 2

{카테고리_이름} Celestron NexStar 130SLT에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Celestron NexStar 130SLT 4 페이지. Celestron nexstar 130slt: quick setup
Celestron NexStar 130SLT에 대해서도 마찬가지입니다: 통신 프로토콜 매뉴얼 (8 페이지), 설치 지침 (1 페이지)

페이지 인쇄

Quick Set-up Guide [cont]

Secure optical tube to fork arm by

tightening the screw located on the

inside of the fork arm assembly.

Select the low power (25mm) eyepiece

and insert it as shown above.

Slide Computerized Hand Control into

the hand control holder as shown above.

While observing, tube should be

positioned as shown above.

Before you can begin observing,you must setup your hand control,

align your finderscope and align your telescope. Step by step

instructions are included in the following Hand Control Setup section.

To attach the finderscope, loosen the silver

screw and slide finderscope into mounting

platform .

Tighten silver screw to secure.

Plug Computerized Hand Control into

the "Hand Control" port on the fork arm.

Before you can use your telescope, you

must insert 8 AA batteries.

Secure finderscope to mounting platform by

tightening the silver screw. The glass window of

the finderscope should be facing towards the

front of the telescope.

Attach plastic hand control holder to the

tripod leg.

Before you begin viewing, please

remember to remove tube lens cap.

Place AA batteries inside the battery

compartment located at the base of the

fork arm.