Celestron NexStar 130SLT Handleiding voor snelle installatie - Pagina 2
Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} Celestron NexStar 130SLT. Celestron NexStar 130SLT 4 pagina's. Celestron nexstar 130slt: quick setup
Ook voor Celestron NexStar 130SLT: Handleiding communicatieprotocol (8 pagina's), Installatie-instructies (1 pagina's)
Pagina afdrukken
Quick Set-up Guide [cont]
10
Secure optical tube to fork arm by
tightening the screw located on the
inside of the fork arm assembly.
13
Select the low power (25mm) eyepiece
and insert it as shown above.
16
Slide Computerized Hand Control into
the hand control holder as shown above.
19
While observing, tube should be
positioned as shown above.
Before you can begin observing,you must setup your hand control,
align your finderscope and align your telescope. Step by step
instructions are included in the following Hand Control Setup section.
11
To attach the finderscope, loosen the silver
screw and slide finderscope into mounting
platform .
14
Tighten silver screw to secure.
17
Plug Computerized Hand Control into
the "Hand Control" port on the fork arm.
20
Before you can use your telescope, you
must insert 8 AA batteries.
12
Secure finderscope to mounting platform by
tightening the silver screw. The glass window of
the finderscope should be facing towards the
front of the telescope.
15
Attach plastic hand control holder to the
tripod leg.
18
Before you begin viewing, please
remember to remove tube lens cap.
21
Place AA batteries inside the battery
compartment located at the base of the
fork arm.