Celestron NexStar+ Hand Control 문제 해결 매뉴얼 - 페이지 5

{카테고리_이름} Celestron NexStar+ Hand Control에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Celestron NexStar+ Hand Control 5 페이지.

Now, click the "Update" button to begin updating your

hand control.

WARNING

Do not disconnect the hand control or power off the

computer or mount while the update is in progress!

The hand control will display "BOOT LOADER Serial CFM

Request" during the update.

When completed, CFM will report "All your devices are up to

date, " and a green circle with a checkmark will appear.

Your hand control is now updated.

NOTE:

If there were problems during the firmware update, you would

need to go through the process again. To do this, first, disconnect the

hand control from the computer. Power cycle the mount and reconnect

the hand control to the computer. Then click "Seek Devices" in CFM.

Once your hand control's firmware has been updated, you

can disconnect the computer cable. Ensure the hand control

is still connected to the mount, and power cycle the mount to

see if the No Response 16/17 error or incorrect model error

goes away. If it does, have fun using your telescope! If it does

not, please contact Celestron Technical Support at

com/pages/technical-support

2835 Columbia Street • Torrance, CA 90503 U.S.A.

1021

celestron.

for further assistance.