Celexon HomeCinema CLR UST 사용 설명서 - 페이지 9

{카테고리_이름} Celexon HomeCinema CLR UST에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Celexon HomeCinema CLR UST 12 페이지. Electric floor high contrast screen
Celexon HomeCinema CLR UST에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지)

페이지 인쇄

Use the tensioning tool (T) and the tensioning springs (M) to attach the

projection screen surface to the frame. Start hooking the tension springs

onto the tensioning rods at the four corners and pull the tensioning tool

to pull the springs into the groove in the frame

Once all four corners are attached with two springs each, place a spring

in the centre of each length. Please also note here that you do the op-

posite side fi rst and only then move on to another point. Continue with

the whole fabric and smooth it down if necessary. After the fi rst springs

have been set, check that the frame is absolutely centred on the corners

and sides of the fabric. If necessary, lift the frame slightly and pull the

fabric out of the surface. The fabric is cut very precisely to fi t the frame

and a slight misplacement may result in the fabric not being able to be

fi tted properly. Here you have to work very precisely and calmly with

suffi cient space. The corners in particular may have to be loosened and

worked around the frame again in such a way that no ripples occur. The

CLR material is comparatively stiff and may need to be reworked in the

corners after a few days.

To do this, place the frame on the protective sheet, loosen the springs in

the corners again and, wearing gloves, work on the affected corner so

that no more ripples are visible. Then re-tension the springs around all

the corners concerned, one after the other.

Fig 12.

Fig 13.