Celexon Professional Plus 사용자 설명서 - 페이지 6

{카테고리_이름} Celexon Professional Plus에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Celexon Professional Plus 8 페이지. Ceiling recessed electric screen
Celexon Professional Plus에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지), 사용 설명서 (6 페이지), 사용 설명서 (8 페이지), 사용 설명서 (11 페이지)

페이지 인쇄

Installing the Screen

materials must be purchased separately). Use the screws (e) and screw into the

top hole, leaving a gap of 1cm. Hang the screen to the wall via the top mounting

hole and check again that the screen is level.You can then tighten this screw.

CAUTION: Tighten the screws, but do not over tighten them. Over tightening

(for example by using a cordless screwdriver) can cause damage and interfere

with the screen's secure hold. If you notice cracks in the side cap, they need

to be replaced. The screen must not be used with defective caps. Please

contact celexon directly for replacement caps (WEB: www.celexon.co.uk,

MAIL: [email protected]).

Then screw through the lower screw hole and make sure that the screws are not

tightened too tight.

Option 3: Suspended ceiling mounting via suspension eyelets (on ceiling

hooks - not included)

ATTENTION! Make sure that you use a stable surface.

Place the plate (f ) (one plate per side cap) underneath the holes of the end cap

and guide the hanging loop (g) through the side cap and plate from above. Then

tighten the loop with the lock nut (h) from below. Measure the distance (A) of

the loops and transfer the distance to the ceiling. Make sure that the loops are in

alignment with each other and that the marking is parallel to the wall.

ATTENTION: Mounting material such as ceiling hooks are not included in this

installation option and must be purchased separately.