AgriProTech BirdTrack 사용자 설명서 - 페이지 7
{카테고리_이름} AgriProTech BirdTrack에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AgriProTech BirdTrack 12 페이지. Acoustic bird repeller
3. Switching on the device
The activation of scaring signals can be programmed in two ways:
a. With the "programmable" alarm, you can choose the start and end times of sound emissions.
b. With the "luminosity" alarm, the signals activate at sunrise and stop at the end of the day,
thanks to the luminosity sensor on the electronic module.
Caution: To avoid the emission of unwanted sound signals, it is important to choose ONE alarm: either the
"programmable" alarm or the "luminosity" alarm.
To start programming the device, press and hold the OK button for 4 seconds (until the AviTrac® screen lights
up). You can access the menu quickly by pressing the OK button again. Information about the device
identification (version of the device and software) appears. You can switch back from this screen by pressing
on the OK button again.
The "Menu" screen appears and indicates if the "programmable"
(a. in the picture opposite) and "luminosity" alarms (b. in the
picture opposite) are active or inactive. Once in the "Home" menu,
press the Select button to browse between the different
programming pages.
The first "Status" screen gives you the following information on
your AviTrac® device:
Whether the memory card is inserted or not
Battery level in %
Battery level in mV
Luminosity in mV
You can press the Select button again to close this screen and browse the following menus.
Hint:
When browsing through the different menus, you can return to the Home menu by holding down the
Select button for a few seconds.
To stop a signal which is currently being emitted, just press the OK button.
7
© 2020 AgriProTech- All rights reserved.
- 02 98 96 08 12 -
www.agriprotech.fr