8STREME 5222 Series 사용 설명서 - 페이지 5
{카테고리_이름} 8STREME 5222 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 8STREME 5222 Series 9 페이지. Above ground automatic swimming pool cleaner
8STREME 5222 Series에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지)
페이지 인쇄
4.10 For optimal performance, place your robot
in the pool at the furthest possible location
-
from the power source.
--
This is the correct length of the cable so
��,,: _
:::;,
-
that the robot can reach all of your pool.
\�
, - .. � -- __ :-:_ , =,;})
,,,
->��___I-:---"'"-
Limit the length of cable in the pool to the
bare minimum for proper swivel
operation. Tie up the excess cable near
the power supply using the supplied
reusable cable ties supplied with the
cable.
�
·j
�
�
-�
�
">�- .
-c>
. ·-- -�
- " Z.
= �
i
✓
�-��, -,�7=t:.�:Y
==-----
-<-=
i
Page8
4.11 To turn off your robot, press the switch on the
power supply to the OFF Position
4.12 Do not remove your robot out of water
immediately after the end of its cleaning
cycle so as not to cause a temperature
shock.
4.13 When the cleaner is no longer used for an
extended period, store your robot indoors.
05 Indicator lights I LED
E
MEANING I DIAGNOSIS
INDICATOR
LIGHT/LED
Plug the power supply into a protected AC voltage supply
A
outlet. Switch the button to the ON position. The blue
light will come on and stay solid blue. If it does not light,
check the supply socket for power. If the blue light blinks,
or does not come on the Power supply is defective and must
be replaced.
B
"No-Twist" Floating Swivel
C
This blue light turns on when the floating cord between the
transformer and the No-Twist float with swivel union is
properly connected and you have turned on the robot. It
indicates that power is reaching the float. If the light does
not come on, check the connections .
D
This green light only lights up when the robot pump is
running. This green light does not light up when the pool
robot has completed its cleaning cycle or during certain
phases of the device's operation (e.g. during a stop before a
change of direction ).
E
When the "No-Twist" float with rotating swivel is connected
to the transformer and you have started the robot, this small
red light indicates that the current is coming out of the float.
You must have both this red light and the blue light (C) on the
float. If you have the blue light on the float but not the red
light, then it is likely that you wil I need to replace the float.
Page9