Galanz P180M18ASL-A0 사용 설명서 - 페이지 12
{카테고리_이름} Galanz P180M18ASL-A0에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Galanz P180M18ASL-A0 16 페이지.
페이지 인쇄
Set lamp:
1.
In standby mode, press and hold PROG button until the the display shows "PROG", "
and "
".
2.
Press and hold number button 2 more than 3 seconds, and repeatedly the operation to cycle select
"LA1"and "LA2".
Code
NOTE: After setting up, press STOP button or no operation within 20 seconds, the system will return to
standby mode and the display will show "0".
Set buzzer scale:
1.
In standby mode, press and hold PROG button until the the display shows "PROG", "
and "
".
2.
Press and hold number button 3 more than 3 seconds, and repeatedly the operation to cycle select
"b F1", "b F2" or "b F3".
Code
b F1
b F2
b F3
NOTE: After setting up, press STOP button or no operation within 20 seconds, the system will return to
standby mode and the display will show "0".
Set power saving mode:
1.
In standby mode, press and hold PROG button until the the display shows "PROG", "
and "
".
2.
Press and hold POWER button more than 3 seconds, and repeatedly the operation to cycle select
"Po1", "Po2", "Po3" and "Po4".
Code
Po1
Po2
Po3
Po4
NOTE: After setting up, press STOP button or no operation within 20 seconds, the system will return to
standby mode and the display will show "0".
Restore factory settings:
1.
In standby mode, press and hold PROG button until the the display shows "PROG", "
and "
".
2.
Press and hold START and PROG buttons at the same time more than 3 seconds, the display will
show "0 0", the factory settings have been restored
NOTE:
After setting up, if press STOP button or no operation within 20 seconds, the system will return to
LA1
Open the door, lamp is on. Close the door, lamp is off
LA2
Open the door, lamp is off. Close the door, lamp is on
Frequency
2 KHz
1 KHz
675 Hz
The delay time of entering mode
1 minute
2 minutes
3 minutes
Off power saving mode
Function
11
", "
"
", "
"
", "
"
", "
"