Hifonics CYCLOPS 3K 제품 설명서 - 페이지 7

{카테고리_이름} Hifonics CYCLOPS 3K에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hifonics CYCLOPS 3K 13 페이지. Mt olympus

페이지 인쇄

D. SettINg uP SYSteMS tO MaxxIMIze

PerfOrMaNCe

ODIN 2K & CYCLOPS 3K

general:

At this point you are ready to get more specific on the settings for the amplifier.

Phase:

Time alignment, typically recommended at 0 degrees unless using multiple amps and subs in both the front

and rear of the vehicle. The Phase can be adjusted to give the perception of bass reaching the listener at

the same time regardless of location.

Subsonic:

This setting acts as a low frequency cut off for your system bass reproduction. The point that you set it at

cuts off any frequencies from reproduction below this point.

exaMPLe:

If you adjust the Subsonic to 25Hz, the amplifier will not play frequencies below 25Hz

but will play frequencies from 25Hz to the chosen Low Pass frequency.

ParaMetrIC baSS eQ

frequency:

This setting is used for selecting the frequency you want to focus your enhancement on. Suggested

enhancement is from 35-45Hz, but you should be careful not to set enhancement below the F3 or -3dB point

of your sub/enclosure combo.

BOOST

WIDTH

CENTER

10dB

30 100Hz

BASS EQ

bandwidth:

This setting controls the amount of frequencies included in the Bass Boost. The bandwidth varies from

narrow to wide in a pyramid style boost with the selected Bass Frequency value being the center.

boost:

This setting adjusts the amount of boost on the selected Bass Frequency and Bandwidth. This setting is

variable from 0-10dB. This feature provides impact to your bass, but if not adjusted correctly, it can be over

used and cause damage to your subwoofers and amplifiers. It is best to slowly turn this setting clockwise

until the desired bass impact is felt. It is not recommended to exceed the 12 o'clock position unless listening

at a low volume or a low recording quality as this can result in high distortion and premature clipping.

Low Pass:

The Low Pass control acts as a ceiling and doesn't allow frequencies above the desired setting to

be reproduced.

exaMPLe:

If you adjust the Low Pass to 80Hz, the amplifier will not play frequencies above

80Hz but will play frequencies from 80Hz to the chosen Subsonic frequency.

Level Control Setup:

Ensure that the Level is turned completely to the left prior to turning the system on. Next you should insert a

CD or other source material that you are familiar with to use as a reference, and turn the head unit volume

control to about 80% of its full setting. The system sound level will of course be very low, and the following

procedures will help you to match the amplifier input sensitivities properly to the head unit output signal level.

It is important to match the amplifier LeVeL input sensitivity to the Radio/CD output sensitivity. This can be

located in the Radio/CD or other source unit owner's manual.

If the Radio/CD output sensitivity is 2 volts, then adjust the amplifier LeVeL input to 2 volts.

If you are not sure what the radio output sensitivity is, follow these

general guidelines:

Turn the level control up slowly, until you hear distortion, then back off a few degrees on the control. If at any

point your amplifier goes into protection, you will need to turn the LEVEL to the left a bit and then try again.

If you reach a point where the output does not increase, stop turning the LEVEL control to the right as the

amplifier/subwoofer combo has reached its maxx output in this application.