ADENDORFF MCJ1000 조립 및 작동 매뉴얼 - 페이지 9
{카테고리_이름} ADENDORFF MCJ1000에 대한 조립 및 작동 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADENDORFF MCJ1000 13 페이지. Wood lathe 14 x 40 inch
페이지 인쇄Main Shaft (27)
Aligning the Centers
1.
Move the Tailstock (39) to the Lathe Tip (28).
2.
Lock the Tailstock down.
3.
Loosen the four screws (26), around the Main Shaft (27).
4.
Swing the Main Shaft forward so the Lathe Tip (28) and the Tip (37) are in line. Then
tighten the Screws (26).
Screws (26)
Main Shaft (27)
Lathe Tip (28)
Changing Speeds
Refer to photo and illustration on the next page.
1.
Make sure the Power Switch (30) is off and the Power Line (1) is unplugged.
2.
Remove the two Screws (3) from the Protecting Cover (11). Remove the Protecting
Cover.
3.
Loosen the Motor Screw (14) this will loosen the Belt Pulley (13).
4.
Raise the lower Belt Pulley (13) this will loosen the Driving Belt (12).
Face plate (29)
Tip (37)
TailStock (39)