Galax Pro 766V-L 사용 설명서 및 안전 지침 - 페이지 11

{카테고리_이름} Galax Pro 766V-L에 대한 사용 설명서 및 안전 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Galax Pro 766V-L 15 페이지. Mini

페이지 인쇄

c.Tighten the lock bolt to secure it in the position.

d.Ensure that the edge guide rests against the wood along its entire length to give

a consistent parallel cuts.

Pocket Cuts

A pocket cut is a cut that must be made inside the area of the work-piece rather than

starting from an outside edge and working inward. Pocket cuts can be very danger-

ous for the novice to attempt because of the need to manually retract the lower

guard and perform a plunge cut which is potential hazardous.

Hold the lower blade guard by the handle.

Rest the front of the base flat against the work-piece with the rear handle related

so the blade does not touch the work-piece.

Start the saw and let the blade reach full speed.

Guide the saw down into the work-piece and make the cut.

: Always cut in a forward direction when pocket cutting. Cutting in

the reverse direction could cause the saw to climb up on the work-piece and back

toward you.

Depth Adjustment

•Unplug your circular saw.

•Loosen the depth clamp

the back of saw.

•Hold the

base plate (3)

piece and lift the body of the saw until the blade is at the

right depth determined by the depth gauge (align the

scale line).

•Secure the

base plate(3)

ATTENTION: Always maintain the correct blade depth

setting. For all cuts the blade depth should not exceed

1/4" below the material being cut. Excessive blade depth

increases the chance of saw KICKBACK.

Angle Adjustment

a.Loosen the

bevel scale bracket (10)

b.Adjust the

base plate (3)

Tighten the

bevel scale

Accessories

lever

(17)on the depth guide at

against the edge of the work

by tightening the lever(17).

for angle adjustment.

to the desired angle between 0°to45°

bracket（10）.

Mini Circular Saw

Owner's Manual & Safety Instructions