Galax Pro 766V-L Руководство пользователя и инструкции по безопасности - Страница 11
Просмотреть онлайн или скачать pdf Руководство пользователя и инструкции по безопасности для Пила Galax Pro 766V-L. Galax Pro 766V-L 15 страниц. Mini
Печатать страницу
c.Tighten the lock bolt to secure it in the position.
d.Ensure that the edge guide rests against the wood along its entire length to give
a consistent parallel cuts.
Pocket Cuts
A pocket cut is a cut that must be made inside the area of the work-piece rather than
starting from an outside edge and working inward. Pocket cuts can be very danger-
ous for the novice to attempt because of the need to manually retract the lower
guard and perform a plunge cut which is potential hazardous.
Hold the lower blade guard by the handle.
a.
Rest the front of the base flat against the work-piece with the rear handle related
b.
so the blade does not touch the work-piece.
Start the saw and let the blade reach full speed.
c.
Guide the saw down into the work-piece and make the cut.
d.
: Always cut in a forward direction when pocket cutting. Cutting in
the reverse direction could cause the saw to climb up on the work-piece and back
toward you.
Depth Adjustment
•Unplug your circular saw.
•Loosen the depth clamp
the back of saw.
•Hold the
base plate (3)
piece and lift the body of the saw until the blade is at the
right depth determined by the depth gauge (align the
scale line).
•Secure the
base plate(3)
ATTENTION: Always maintain the correct blade depth
setting. For all cuts the blade depth should not exceed
1/4" below the material being cut. Excessive blade depth
increases the chance of saw KICKBACK.
Angle Adjustment
a.Loosen the
bevel scale bracket (10)
b.Adjust the
base plate (3)
Tighten the
bevel scale
Accessories
lever
(17)on the depth guide at
against the edge of the work
by tightening the lever(17).
for angle adjustment.
to the desired angle between 0°to45°
bracket（10）.
Mini Circular Saw
Owner's Manual & Safety Instructions