909 OSC400 사용 설명서 - 페이지 6

{카테고리_이름} 909 OSC400에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 OSC400 16 페이지. Oscillating multi-tool

Never use damaged or bent blades. They will be brittle and

break easily possibly causing injury to the operator.

Never touch a saw blade immediately after using the tool.

The blade will be extremely hot and will burn your hand.

Only use accessories designed for use with this tool.

WARNING.

We recommend the use of a residual current

device with a residual current rating of 30mA or less.

Wear goggles

Wear ear muffs

Wear a breathing mask

Accessories

1 x 5 mm Hex key

1 x Plunge cutting saw blade for cutting softwood, plastic &

plasterboard

1 x Half circle saw blade for cutting soft metals, wood,

plastics & plasterboard

1 x Scraper blade

1 x Sanding pad

3 x Sanding sheets: 1 x 60 grit, 1 x 120 grit, 1 x 240 grit

WARNING:

Use only accessories that are recommended for

this oscillating tool. Follow the instructions that accompany

the accessories. The use of improper accessories may

result in injury to the operator or damage to the tool.

Before using any accessory, carefully read the instructions

or the owner's manual for the accessory.

WARNING:

If any part is missing or damaged, do not plug

the tool into the power source or install any accessory until

the missing or damaged part is replaced.

Due to modern mass production techniques, it is unlikely

that your 909 Power Tool is faulty or that a part is missing.

If you find anything wrong, do not operate the tool until the

parts have been replaced or the fault has been rectified.

Failure to do so could result in serious personal injury.