909 OSC400 사용 설명서 - 페이지 8

{카테고리_이름} 909 OSC400에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 OSC400 16 페이지. Oscillating multi-tool

Installing accessories

All accessories are installed on the oscillating tool in

a similar manner. For the purposes of describing the

accessory installation, the plunge cutting blade is used.

DANGER:

Always remove the plug from the power source

before installing or removing accessories or sandpaper.

Failing to remove the plug from the power source may result

in the tool accidentally being started and causing serious

injury to the operator.

1. Remove the screw and washer from the accessory holder

by turning the screw counter clockwise. Use the 5mm hex

key if the screw is too tight to be removed by hand.

2. Place the blade on the accessory holder.

Notes:

a) Make sure the alignment holes in the blade fit over the

alignment pins in the accessory holder and the printed

side of the blade is facing the tool.

b) The blade can be mounted at various angles left or

right of centre if required.

3. Thread the screw through the washer and the blade and

into the accessory holder threaded hole.

4. Turn the screw clockwise until it is finger tight.

Notes:

a) Check to make sure the convex curve of the washer

is facing the head of the screw and the slots in the

edge of the washer fit over the alignment pins in the

accessory holder.

b) Make sure the alignment holes in the blade are still

mated with the alignment pins in the accessory holder.

5. Firmly tighten the screw with the 5 mm hex key.

Note:

Check to make sure the holes in the blade are still

mated with the alignment pins on the accessory holder after

the screw is fully tightened.

1. Install the hook & loop sanding pad onto the tool.

2. Firmly press the sandpaper (9) onto the hook & loop pad.