909 OSC400 사용 설명서 - 페이지 9

{카테고리_이름} 909 OSC400에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 909 OSC400 16 페이지. Oscillating multi-tool

페이지 인쇄

1. Accessories

Notes:

a) Place the sandpaper so the holes in the sandpaper

line up with the matching holes in the hook & loop pad.

b) Press the sandpaper firmly onto the hook & loop pad.

3. To remove the sandpaper, simply peel the sandpaper

way from the hook & loop pad.

Installing dust extraction fitting and adaptor

1. Push the long flat tube of

dust extraction tube (3) into

the front part with circular

flange on it. Then push on

the dust extraction adaptor to

the back section.

2. Place the circular flange over

the blade bolt and ensure

it is sitting within the metal

casing.

3. Using the C-clip provided

(12) locate this into the side

hole location points and push

until clips in and holds the

extraction tube securely.

On/off switch

1. To turn the tool ON, slide the

ON/OFF switch (1) toward

the front of the tool.

2. To turn the tool OFF, slide

the ON/OFF (1) switch

toward the rear of the tool.

Speed control wheel

The speed of the tool can be adjusted to run the tool at

speeds varying between 10,000 OPM and 18,500 OPM by

rotating the speed control wheel located toward the rear of

the tool housing.

1. To increase the speed, rotate

the speed control wheel (2)

toward the left side of the

tool.

2. To decrease the speed,

rotate the speed control

wheel (2) toward the right

side of the tool.

Note:

Speed #1 is the lowest

speed. MAX is the highest speed.

The optimal speed setting will vary depending upon the type

of accessory being used, the surface being worked and the

complexity of the project. For general recommendations,

see the chart below.